User guide

Training Manual
F-CIM Lab
9 - 10
Figure 9 .4.
FCIM VIEW
The Erase Mode: The ERASE command is used for clearing the entire F-CIM program.
Added protection is provided in the form of a confirmation question.
To erase the program code:
• While View is displayed at the bottom, press F2 until you see ERASE at the
bottom and then press the F3 key. See the next figure.
• The confirmation question (N SURE? Y) will be displayed at the bottom next.
Selecting the F3 (Y) will clear the program. Selecting F1 (N) will abort the
selection.