Manual

3.4.2 DISPLAYING A DATAPOINT
The following procedure illustrates how to display the contents of datapoint C175, which is ANI2
Alarm Limit 1. Figure 3-9 contains supporting illustrations for the display procedure described in
Table 3-2. (Notice in these illustrations that ANI-2 Alarm Limit 1 is set at 80.)
Table 3-2. Procedure to Display a Datapoint
Step Press
Once
Shift
Result
Press to
Locate
Target
Char.
Result
1
●
Puts instrument in engineering mode.
2If
DISPLAY
does not appear, press
2
.
3
3
Displays entry line:
POINT .
4CPuts
C
on entry line:
POINT .C
.
5.C
∆
1Shifts
C
and puts
1
on entry line:
POINT .C1
.
6.C1
∆
7Shifts
C1
and puts
7
on entry line:
POINT .C17.
7.C17
∆
5Shifts
C17
and puts
5
on entry line:
POINT .C175.
8
3
Enters address to display datapoint contents.
The address with the contents are displayed as
follows:
C175 80.0000
9
●
Returns instrument to operator mode.
Note:
∆
= space.
Addressing a Datapoint Displaying a Datapoint Contents
Figure 3-9. Displaying a Datapoint
80
Section 3. Displays and Push Buttons
3-9