Use and Care

www.micromatic.com

ELECTRONIC TEMPERATURE CONTROL WITH DISPLAY

NOTE: When the unit leaves the factory the electronic thermostat is pre-set to the

following parameters:

Temperature Scale: F (Fahrenheit)

Setpoint: 29° F

Differential: 3° F

NOTE: To ensure the correct operation of your unit these parameters must be adhered to.

ADJUSTING ELECTRONIC THERMOSTAT

HOW TO SEE THE SETPOINT

1. Push and immediately release the SET key: the display will show the set point value.

2. Push and immediately release the SET key or wait for ve (5) seconds to display the probe value again.

HOW TO CHANGE THE SETPOINT

1. Push the SET key for more than two (2) seconds to change the set point value.

2. The value of the set point will be displayed and the * LED starts blinking.

3. To change the Set value push the (up) or (down) arrows.

4. To lock the new set point value push the SET key again and wait 15 seconds.