Use and Care

8
// www.micromatic.com
3.5 DATA PLATE
The data plate in located inside the unit, near the top front left corner. Under no
circumstances should the data plate be removed from the unit. The data plate is
essential to identify the particular features of your unit and is of great benet to
installers, operators and maintenance personnel.
3.6 ELECTRICAL CONNECTIONS
Refer to the amperage data in this manual or on data plate and your local code or the
National Electrical Code to be sure unit is connected to the proper power source. Verify
correct incoming voltage according to the Data Plate information.
A protected circuit of the correct voltage and amperage must be run for connection
of the supply cord. Unit must be grounded and connected in accordance with NEC
Article 422 Appliances.
DANGER: Power must be turned off and disconnected from the power source
whenever performing maintenance, repair or cleaning the condensing unit. If
unit still running when power is off, disconnect power at the circuit breaker
before unplugging the unit.
WARNING: Unit and compressor warranties are void if failure is due to improper
electrical installation.