Use and Care

5
// www.micromatic.com
3 // INSTALLATION
3.1 UNCRATING
Cut and remove the outer packaging. Cut the (4) four clamps that hold the refrigerator
to the skid lift the unit off the skid. If machine was laid down during this operation leave
the cabinet up right for 24 hours before plugging into power source.
3.2 SEALING
WHEN SANITATION CODES REQUIRE SEALING TO FLOOR, THIS METHOD MAY
BE USED
1. Tip cabinet and apply a bead of silicone seal on bottom edge of the base.
2. Return cabinet to upright position and using proper equipment, lift cabinet into location.
Heavy appliances should not be used on the same circuit with the cooler.
CAUTION: If an extension cord is necessary, use only a three wire grounding type of
wire, size 16 AWG or heavier; do not exceed 20 feet in length. The use of ungrounded
cords or overloaded circuit voids compressor warranty.