Instructions / Assembly

Install chip guard on compound rest.
18
Connect the black and the white wires to the two
terminals on the safety switch as shown.
Install cover as shown.
11
10
16
Install rear splash guard with 5 screws.
17
15
Now, mate the white connectors to their appropriate
slots on the boards.
12
20
14
Install/mate the digital readout (optional) to its socket
and test operation.
8
Please refer to the wiring diagram found in the
instruction manual for assistance in this section.
Remove the 4 screws that hold the main circuit board
inside the electrical control box and gently pull out the
circuit board to gain access to wire terminals. Locate
the 5-slot (screw type) terminal post. N and L are
already installed. Install W, V and U cables to their
terminals. Note: the cables are marked accordingly.
Install control box to headstock with 4 screws. Be sure
grommet is properly engaged and wires cannot foul
the lead screw. Do not over-tighten screws or you will
crack the plastic control box.
Install gear box cover with 2 screws.
Install chuck and tailstock.
13
Notice this rubber grommet (protective cover) on the
lead screw. It will be mated with the electrical box to
prevent debris from entering the box and causing
damage to components.
Check all other connections and ensure good contacts.
Now, reinstall the circuit board inside the box with the
4 screws previously removed. Note: Screws may not
tighten on the board; this is normal. Do not over-tighten.
Note: You can check the operation of the machine
before going further by carefully making sure all
switches are set to “Off” and plugging the machine into
the line power socket. Be cautious of high voltage
present in the electrical box and be sure nothing
touches any electrical components. Be sure the speed
control is turned all the way toward “Off”
(counterclockwise). Release safety switch cover by
pushing in tab on left side of switch.
Place the directional switch to forward. Press the green
button. Green power light should illuminate and the
yellow fault light should be off. Turn up the speed
control a little to view chuck rotation. If it turns
counterclockwise while looking at it from the tailstock,
it is turning in the correct direction. Turn down the
speed control to “Off.” Change directional switch to
reverse and test its direction by again turning up the
speed. It should turn clockwise. If all is functioning
properly, then power down the controls and unplug the
machine from line power.
Install all remaining handles, cranks, caps, covers and
shields in the locations shown in the assembly diagram.
19
340 Snyder Avenue, Berkeley Heights, NJ 07922
Tech Support 908-464-1094
www.micromark.com [e-mail]
9