Technical Manual

CLASSIFICATION: PUBLIC DATE OF PRINT: 20 January 2021
Installation
LiveLink 4 units are designed to be installed both within the vehicle cab in a protected environment and
externally fitted.
Depending on the application the device may be permanently powered, or only powered periodically. In
either application, the LiveLink 4 is designed to make efficient use of the power available through the use of
sleep modes when there is no activity.
When selecting a suitable mounting location, please be aware of:
• Excessive temperatures
• Corrosive fluids
• Areas where the unit may obstruct the driver's view or impede the operation of the vehicle
• Locations that may shield the unit affecting GPS and/or GPRS reception.
• Unit and antenna separation distance of at least 20cm from all persons, animals and other
antennae or transmitters.
• Local or international regulations regarding the fitment of equipment within vehicles.
The installation must be carried out following FCS1362:2010 or later, by a Microlise approved installer. The
recommend installation to vehicles is to be mounted on 2 x M5 fixings, tightened to 2Nm.
For installation the unit must be fused on the power input at 2A, and on the ignition input at 1A using
automotive fuses and fuse holders tested to relevant safety standards appropriate for the intended country of
use.
The minimum connections to the vehicle for unit operation are listed below.
Connection
Pin Number
Fused
Power
4M
Yes – 2A
Ignition
2M
Yes – 1A
Ground
3M
No
Ignition Ground
2L
No
Refer to relevant product guidelines and vehicle surveys for installation specifics.