Operating instructions

TM 11574A-OI
2-39
Table 2-9 DataCORDER Function Code Assignments
NOTE
Inapplicable Functions Display “---------”
To Access: Press ALT. MODE key
Code
No.
TITLE DESCRIPTION
dC1
Recorder Supply
Temperature
Current reading of the supply recorder sensor.
dC2
Recorder Return
Temperature
Current reading of the return recorder sensor.
dC6-13
Network Data
Points 1-8
Current values of the network data points (as configured). Data point 1 (Code
6) is generally the humidity sensor and its value is obtained from the Control-
ler once every minute.
dC14
CargoProbe4
Temperature
Current reading of the cargo probe #4.
dC15-19 Future Expansion These codes are for future expansion, and are not in use at this time.
dC20-24
Temperature
Sensors 1-5
Calibration
Current calibration offset values for each probe: supply and return. These
values are entered via the interrogation program.
dC25 Future Expansion This code is for future expansion, and is not in use at this time.
dC26,27 S/N, Left 4, Right 4
The DataCORDER serial number consists of eight characters. Function
code dC26 contains the first four characters. Function code dC27 contains
the last four characters. (This serial number is the same as the Controller
serial number)
dC28 Minimum Days Left
An approximation of the number of logging days remaining until the Data-
CORDER starts to overwrite the existing data.
dC29 Days Stored Number of days of data that are currently stored in the DataCORDER.
dC30
Date of last Trip
start
The date when a Trip Start was initiated by the user. In addition, if the
system goes without power for seven continuous days or longer, a trip start
will automatically be generated on the next AC power up.
dC31 Battery Test
Shows the current status of the optional battery pack.
PASS: Battery pack is fully charged.
FAIL: Battery pack voltage is low.
dC32 Time: Hour, Minute Current time on the real-time clock (RTC) in the DataCORDER.
dC33 Date: Month, Day Current date (month and day) on the RTC in the DataCORDER.
dC34 Date: Year Current year on the RTC in the DataCORDER.
dC35
Cargo Probe 4
Calibration
Current calibration value for the Cargo Probe. This value is an input via the
interrogation program.