Service manual

8
3. Assemble the 1/8” Screws & Toggle Wings
into the Faucet Base. Adjust the Wings
approximately 1” plus the thickness of the
mounting surface away from the bottom of the
Faucet Base.
4. Place the Base Assembly through the mounting
hole on the sink or counter top.
Drop the handle of the Wrench through the
Faucet Base opening. This will separate and
orient the Toggle Wings. Position the Faucet
Base so that the arrows are pointing in the
direction that the faucet handle will face.
Tighten the 1/8” Screws with a Phillips
screwdriver. When the Toggle Wings make
contact with the mounting surface, adjust
the Faucet Base to the exact desired position.
Tighten the 1/8” Screws an additional 2 –3 turns
while holding the Faucet Base in place.
TAB
HOSE BARBS
3/8” QUICK
CONNECT FITTING
BLACK 3/8” POLYTUBE
(TO DRAIN CLAMP)
BLACK 1/4” POLYTUBE
(TO DRAIN PORT
ON RO SYSTEM)
BLUE 3/8” POLYTUBE
(PRODUCT OUTLET)
5. Connect the tubing to the Faucet. Push
the Blue 3/8” Polytube into the 3/8” Quick
Connect Fitting. Push the Black 3/8” Polytube
onto the large Hose Barb. Push the Black ¼”
Polytube onto the small Hose Barb.
6. Determine which direction the handle should
face (right or left). As shown, it can be
mounted in two directions. With the handle
facing the chosen direction, slide the fastened
Polytubes through the Faucet Base and slide
the Faucet Assembly into the Faucet Base,
lining up the tabs on the Faucet with the slots
on the Base. The Faucet Assembly may have
to rotate slightly to get the tabs into the slots.
When aligned, apply rm downward pressure
to get the Faucet to fully seat. After the Faucet
Assembly is seated, lock it into place by
rotating it clockwise about 30 degrees.