Instruction Manual

6. How to Reload a New Probe Cover
NOTE:
• In order to avoid cross-contamination, please reload a new probe
cover for each measurement.
• Please check if the probe cover is fitted on firmly before use
(please see the diagrams below); If the probe cover is broken,
discard the probe cover and reload a new one immediately.
(X) Incorrect (O) Correct
5 6
(3) Completely push the
probe into the probe
cover holder hole.
(4) Take out the probe with
cover attached tightly.
5. Control Displays and Symbols
(1) Place a probe cover onto
the storage case hole
with paper side upwards.
(2) Take the unit, vertically
penetrate the probe into
the center part of the
probe cover.
LCD Display Display
Meaning
Description
All segments
displayed
Press the O/I button to turn
on the unit, all segments
will be shown for 2 seconds.
Memory The last reading will be
shown on the display auto-
matically for 2 seconds.
Ready The unit is ready for mea-
surement, the «°C» or «°F»
icon will keep flashing.
Measurement
complete
The reading will be shown
on the display with the
«°C» or «°F» icon steady,
the unit is ready for the
next measurement, when
the «°C» or «°F» icon is
flashing again.
Out-of-ear
temperature
indication
A crossed-ear-icon is shown
on the LCD if the reading
falls outside the range 32.0
~ 42.2 °C / 89.6 ~ 108.0 °F.
Low battery
indication
When the unit is turned on,
the battery icon will keep
flashing to remind the user
to replace the battery.
EN