Instruction Manual
EN
19
WatchBP Office
• Only activate the pump when the cuff is connected to the device.
• Do not use the device if you think it is damaged or if anything appears unusual.
• Read the further safety instructions in the individual sections of the instruction manual.
Observe the storage and operating conditions as described in the “Technical
specications” section of this manual.
Protect the device from water and
moisture
Protect the device from extreme
heat and cold
Protect the device from direct
sunlight
Device care
Use a soft cloth with one of the following
recommended cleaning solutions to wipe the exterior
of the device:
• Mild soap and water.
• Hydrogen peroxide solution (3% diluted with water).
• Sodium hypochlorite solution (1:10 dilution of
household chloride bleach in water).
Cleaning the cuff
Remove the bladder. Fold and place the cuff cover
inside a washing bag. Wash the cuff cover with warm
water (43°C; 110°F) and a mild detergent in the
washing machine.
Pasteurization: wash the cuff cover in 75°C(167°F)
hot water for 30 minutes.
M (Medium size) for upper arm
22 - 32 cm (8.7 - 12.6 inches)
With air tube 130 cm
L (Large size) for upper arm
32-42 cm (12.6-16.5 inches)
With air tube 130 cm
MODE
Accuracy test
We recommend the device to be tested for accuracy
every 2 years or after mechanical impact (e.g. Being
dropped). Please contact Microlife to arrange an
accuracy test.
Disposal
Batteries and electronic instruments must be disposed
of in accordance with the locally applicable regulations,
and not as domestic waste.
Protect the device from impact and
drops
Avoid proximity to electromagnetic
fields, such as those produced by
mobile phones
Never open the device
Do not iron the cuff!
Do not use the device in the MRI
environment.