Users Manual

5.7. Setting the medication reminder

This instrument allows you to set two alarm times at which an

alarm signal will then be triggered. This can be a useful aid, for

instance as a reminder to take medication or to remind you to

take your blood pressure at the same time each day.

1. To set an alarm time, press the time button (the instrument

must have been switched off beforehand), and immediately

afterwards the "M" button, and hold both down until the bell

symbol appears in the bottom left of the display. Then release

both buttons. The flashing "1" in the display indicates that the

first alarm time can now be set.

2. Press the time button to set the hours – the hours display

flashes and pressing the "M" button allows you to set the

alarm hour. To confirm, press the time button.

3. The minute display will now flash. The minutes can be set

using the "M" button. To confirm, press the time button again.

4. The bell symbol will now flash. Use the "M" button to select

whether the alarm time is to be active (bell) or inactive

(crossed-out bell). To confirm, press the time button.

To set a second alarm time, proceed as above but if the "1" flashes,

press the "M" button to select "2" and confirm with the time button.

•

An active alarm time is indicated by the bell symbol in the display

• The alarm sounds at the set time every day.

• To switch off the alarm when it is sounding, press the ON/OFF

button.

• To permanently switch off the alarm, proceed as above (steps

1-4) and select the crossed-out bell symbol. This will then dis-

appear from the display.

• The alarm times must be re-entered each time the batteries

are replaced.

TIME PM

MV1-3B-HM IB-FINAL-042120-rev1-051320.qxp_MLU3AC1-JAN05-2 5/13/20 2:22 PM Page 21