Users Manual

5.5. Memory: reviewing readings

At the end of a measurement, this monitor automatically stores each

result with date and time. This unit stores 120 memories for each of 2

users.

Viewing the stored values

With the unit off, press the "M" button. The display first shows "A,"

then shows an average of all measurements stored in the unit. Please

note: Measurements for each user are averaged and stored separately.

Be certain that you are viewing the measurements for the correct user.

Pressing the "M" button again displays the previous value. To view a

particular stored memory, press and hold the "M" button to scroll to

that stored reading.

Memory full

When the memory has stored 120 results, a new measured value is

stored by overwriting the oldest value.

Clear all values

If you are sure that you want to permanently remove all stored values,

hold down the "M" button (the instrument must have been switched off

beforehand) until "CL" appears and then release the button. If you do

not want to clear the values, press the ON/OFF button. To permanently

clear the memory, press the "M" button while "CL" is flashing.

Individual values cannot be cleared.

5.6. Stopping a measurement

If it is necessary to interrupt a blood pressure measurement for any rea-

son (e.g., the patient feels unwell), the ON/OFF button can be pressed

at any time. The device then immediately lowers the cuff pressure auto-

matically and enters sleep mode.

MV1-3B-HM IB-FINAL-042120-rev1-051320.qxp_MLU3AC1-JAN05-2 5/13/20 2:22 PM Page 20