Product Info
Comment: If it is not possible to fit the cuff to your left arm, it can also be placed on your right
arm. However, all measurements should be made using the same arm. Comparable blood
pressure measurements always require the same conditions.
Fitting the Rigid Cuff (6025N model)
1. The cuff is pre-formed for easier use. Remove tight or bulky clothing from your upper arm.
2. Wrap the cuff around your upper left arm. The rubber tube should be on the inside of your
arm extending downward to your hand. Make certain the cuff lies approximately 1/2−3/4”
(1−2 cm) above the elbow.
Important! The red strip on the edge of the cuff (Artery Mark) must lie over the artery which
runs down the inner side of the arm.
3. To secure the cuff, wrap it around your arm and press the hook-and-loop closure together.
4. There should be a little free space between your arm and the cuff. You should be able to fit
two fingers between your arm and the cuff. Cuffs that don’t fit properly result in false
measurement values. Measure your arm circumference if you are not sure of proper fit.
5. Lay your arm on a table (palm upward) so the cuff is at the same height as your heart.
Make sure the tube is not kinked.
6. Remain seated quietly for at least two minutes before you begin the measurement.
Taking Blood Pressure Measurement
After the cuff has been appropriately positioned and connected to the monitor, the measurement
can begin:
1. Press the «ON/OFF» button. The built-in pump begins to inflate the cuff. In the display, the
increasing cuff pressure is continually displayed.
2. After a suitable inflation pressure has been reached, the pump stops and the pressure
gradually falls, with cuff pressures being displayed. If that inflation pressure is not sufficient, the
monitor automatically re-starts.
3. When the instrument detects a pulse, the heart symbol in the display starts to flash and a
beep is heard for every heartbeat. (may want to show symbol?)
4. When the measurement has concluded, the systolic and diastolic blood pressures and pulse
rate now appear in the display. Cuff deflates.
5. The appearance of this symbol XXXX(add to symbols table) signifies that an irregular
heartbeat was detected. This indicator is only a caution. It is important that you be relaxed,
remain still and do not talk during measurements.
NOTE: We recommend contacting your physician if you see this indicator frequently. See
Section x (page x irregular heartbeat detector)) for more information.
6. The measurement readings remain on the display until you switch off the instrument. If no
button is pressed for a period of one minute the instrument switches itself off in order to
preserve the batteries. 7. When the unit is set to the MAM setting, three separate
measurements will take place in succession after which your result is calculated and displayed
as a single, averaged measurement. There is a 15-second resting time in-between each
measurement. A countdown indicates the remaining time before the second and third readings
will begin.
NOTE: If one of the measurements causes an error message, it will be repeated one more time.
If any additional error occurs, the measurement will be discontinued, and an error code will be
displayed.
Expanding the averaged measurement to see the three individual readings: