User manual

GPX Pro Manual47
© 2009 XT Racing
When you change the descriptive name of an analog channel, if the name has been defaulted to
(e.g.) “INPUT 1”, then on the first key press the name will be cleared to allow entry of the new
name.
You may “de-calibrate” (i.e., remove calibration information for ) an analog channel. The primary
use for this would probably be for a temperature-capture channel, where many calibration points
are set. So, for example, if a mistake is made in the calibration for a temperature channel, since
an individual temperature-point cannot be deleted, you must delete all calibration information
for that channel, then re-calibrate.
Don’t worry if you mess up a calibration – you can re-do a calibration at any time.
If a channel is not calibrated, its value will display as “-“.
1.8 Time and Distance Meters
The GPX has two internal time and distance meters. These each keep track of the active time and
distance the vehicle traveled, whenever the GPX is receiving a valid GPS signal.
The two meters are independent of each other, and either may be cleared at any time.
1.9 Miscellaneous Information