User guide

Chapter 2 MicroLogPRO
32
2.3.2. Working Modes
MicroLogPRO is always set in one of 5 possible modes:
Stop – MicroLogPRO is idle and is not recording.
Run – MicroLogPRO is recording data. It will stop recording
automatically when its memory has reached full capacity
(52,000 samples with one sensor).
Cyclic Run – Similar to Run mode, but MicroLogPRO will
record over the old data when the memory is full, beginning
with the earliest data recording.
Timer Run – MicroLogPRO can be configured to start
recording at a predetermined time. When MicroLogPRO is
set for such a run, its status is set to Timer Run.
Push to Run – MicroLogPRO will only begin logging data
when the user pushes either the left or right buttons.