User guide

Chapter 1 MicroLog
20
Note: The MicroLog uses a 1/2AA 3.6V lithium battery.
1. Unfasten the four screws on the back of
the MicroLog.
2. Carefully remove the back cover
3. Replace the battery, and be sure to insert
the new battery into the correct
corresponding polarities (look for the “+”
symbol next to the positive terminal)
4. Carefully reposition the electronic board on
MicroLog’s back cover and make sure that
the humidity sensor is placed in its
compartment.
5. Refasten the four screws on the back of
the MicroLog.