User guide

MicroLog Chapter 1

Run – MicroLog is recording data. It will stop recording

automatically when its memory is full (16,000 recordings).

Cyclic Run – Same as Run, but MicroLog will record over

the old data when the memory is full, beginning with the

earliest data recording.

Timer Run – MicroLog can be configured to start recording

at a predetermined time. When MicroLog is set for such a

run, its status is set to Timer Run. Once MicroLog starts

recording, its status changes to either Run or Cyclic Run,

depending on the desired configuration.

1.2.3. MicroLog’s Connections

Note: MicroLog ships with a rubber plug that covers the rear

socket. The plug protects the socket from moisture. Unless

you are using the socket leave the plug in.