Technical data

MicroLab PC
30 Agilent MicroLab Software Operation Manual
12 It should also be noted that the Sample Continuity Check can be
used to ensure that the system is aligned to the sample
throughout the measurement.
13 Click Save As and save the method.
14 For use on the handheld PC, the method should be transferred to
the MicroLab Mobile/Methods folder on the mobile device.
15 In MicroLab Mobile, the Pre-Sample Alignment Check will be
displayed as a red/yellow/green bar graph on the Sample
Alignment page. The sample should be rotated or aligned in order
to reach the maximum value on the bar graph.
Transferring edited methods to MicroLab Mobile
After completing modifications to a method in MicroLab PC or
MicroLab Lite, the files should be transferred to the embedded or
handheld PC for use. There are two ways to copy files; by using My
Computer, or by transferring them automatically via MicroLab Lite.
Using MicroLab Lite Synchronize
To transfer methods to MicroLab Mobile using MicroLab Lite
Synchronize:
1 Connect the handheld or embedded PC to the computer
containing MicroLab PC and start ActiveSync as specified in
‘Initial Setup’ Steps 1 and 2 on Page 9.
2 Open MicroLab Lite on the computer.
3 Click Advanced Features.
4 Click MLp Report Settings.
5 If no connection is listed, click New.
6 In the dialog box, enter the serial number of the instrument and
select what options are to be synchronized. Reports, Results and
Methods can be synchronized. In addition, reports can be
automatically printed by specifying the desired printer.
7 Once the device to be synchronized has been selected, click OK.
8 To transfer files, highlight the desired handheld PC from the list
and click Synchronize.