Installation manual

© Microhard Systems Inc. 81
4.0 Configuration
Image 4-40: Firewall > General
4.6.2 Firewall > General
The General Firewall settings allow users to enable or disable the firewall, and to decide which
areas of the modem to protect. The Firewall can also be reset to factory defaults from this area
of the WebUI.
Firewall Status
When enabled, the firewall settings are in effect. When disabled,
none of the settings configured in the menu’s below have an effect,
the modem is “open”.
Values
Disable / Enable
WAN Remote Management
Allow remote management of the VIP4G on the WAN side using the
WebUI on port 80(HTTP), and 443 (HTTPS). If disabled, the
configuration can only be accessed from the LAN (or 4G if
enabled)..
Values
Disable / Enable
4G Remote Management
Allow remote management of the VIP4G from the 4G side of using
the WebUI on port 80(HTTP), and 443 (HTTPS). If disabled, the
configuration can only be accessed from the LAN (or WAN if
enabled)..
Values
Disable / Enable