Installation manual

© Microhard Systems Inc. 63
4.0 Configuration
Image 4-32: Wireless > Radio Configuration
4.3.2 Wireless > Radio1
Radio1 Phy Configuration
The top section of the Wireless Configuration allows for the configuration of the physical radio
module. You can turn the radio on or off, and select the channel bandwidth and frequency as
seen below.
This option is used to turn the radio module on or off. If turned
off Wireless connections can not be made. The default is On.
Radio
Values (selection)
On / Off
The Mode defines which wireless standard to use for the
wireless network. The VIP4G supports all 802.11a/b/g/n
modes as seen here. Select the appropriate operating
mode from the list.
The options below are dependant and vary on the
operating mode chosen here.
Mode
Values (selection)
802.11B ONLY
802.11BG
802.11NG-High Throughout 2.4GHz
802.11A ONLY
802.11NA-High Throughout 5GHz
Only appears when using 802.11b, bg or a modes. Lower
channel bandwidths may provide longer range and be less
susceptible to noise but at the trade off of data rates. Higher
channel bandwidth may provide greater data rates but will be
more susceptible to noise and shorter distance potentials.
Channel BandWidth
Values (selection)
20MHz Normal Rate