Installation manual

© Microhard Systems Inc. 50
4.0 Configuration
GRE Tunnel Local Status
Enable / Disable the GRE Tunnel.
Values (selection)
Disable / Enable
Multicast
Enable / Disable Multicast support over the GRE tunnel.
Values (selection)
Disable / Enable
ARP
Enable / Disable ARP (Address Resolution Protocol) support over
the GRE tunnel.
Values (selection)
Disable / Enable
TTL
Set the TTL (Time-to-live) value for packets traveling through the
GRE tunnel.
Values (value)
1 - 255
Local WAN IP
This is the WAN IP Address of the VIP4G, this field should be
populated with the current WAN IP address.
Values (IP Address)
(varies)
Local Subnet Gateway
This is the IP Address of the local network.
Values (IP Address)
(varies)
Remote Subnet
The is the IP Address of the remote network, on the remote side of
the GRE Tunnel.
Values (IP Address)
(varies)
Remote WAN
Enter the WAN IP Address of the VIP4G or other GRE supported
device in which a tunnel is to be created with.
Values (IP Address)
(varies)