Installation manual

© Microhard Systems Inc. 48
4.0 Configuration
Specify the Gateway used to reach the network specified
above.
Gateway
Values (IP Address)
192.168.168.1
Enter the Netmask for the destination network.
Netmask
Values (IP Address)
255.255.255.0
In some cases there may be multiple routes to reach a
destination. The Metric can be set to give certain routes priority,
the lower the metric is, the better the route. The more hops it
takes to get to a destination, the higher the metric.
Metric
Values (Integer)
255.255.255.0
Define the exit interface. Is the destination a device on the LAN,
or the WAN?
Interface
Values (Selection)
LAN
WAN
None
Dynamic Route Configuration
The VIP4G can support Dynamic Routing on the LAN and Wireless Ports. The VIP4G will
communicate with other devices running RIPv2 to automatically populate a routing table.
Enable /Disable Dynamic Routing.
Route Mode
Values (Selection)
Enable
Disable
The Name field allows a user to give the Network a name for
reference.
Name
Values (Characters)
(varies)
Specify the IP and Subnet of any networks that are to be
advertised to other devices via dynamic routing.
Network
Values (IP/Subnet)
(varies)