Installation manual

© Microhard Systems Inc. 36
4.0 Configuration
4.1.5 System > Maintenance
Reset to Default
The VIP4G may be set back to factory defaults by using the Reset to Default option under
System > Maintenance > Reset to Default. *Caution* - All settings will be lost!!!
Image 4-12: Maintenance > Reset to Default / Backup & Restore Configuration
Use this field to name the configuration file. The .config extension will automatically be added to
the configuration file.
Name this Configuration / Backup Configuration
Restore Configuration file / Check Restore File / Restore
Use the ‘Browse’ button to find the backup file that needs to be restored to the unit. Use the
‘Check Restore File’ button to verify that the file is valid, and then the option to restore the
configuration is displayed, as seen above.
Backup & Restore Configuration
The configuration of the VIP4G can be backed up to a file at any time using the Backup
Configuration feature. The file can the be restored using the Restore Configuration feature. It is
always a good idea to backup any configurations in case of unit replacement. The configuration
files cannot be edited offline, they are used strictly to backup and restore units.