Installation manual

4.0 Configuration

4.0 Web User Interface

Initial configuration of an VIP4G using the Web User (Browser) Interface (Web UI) method

involves the following steps:

 configure a static IP Address on your PC to 192.168.168.10 (or any address on the

192.168.168.X subnet other than the default IP of 192.168.168.1)

 connect a VIP4G LAN ETHERNET port to PC NIC card using an Ethernet cable

 apply power to the VIP4G and wait approximately 60 seconds for the system to load

 open a web browser and enter the factory default IP address of the unit: 192.168.168.1

 logon window appears; log on using default Username: admin Password: admin

 use the web browser based user interface to configure the VIP4G as required.

 refer to Section 2.0: Quick Start for step by step instructions.

In this section, all aspects of the Web Browser Interface, presented menus, and available

configuration options will be discussed.

Image 6-1: WebUI