Installation manual

3.0 Hardware Features

3.1 VIP4G

The VIP4G is a fully-enclosed unit ready to be interfaced to external devices.

Any VIP4G may be configured as an Access Point (Router or Bridge), Station/Client, Repeater

or Mesh Node. This versatility is very convenient from a ’sparing’ perspective, as well for

convenience in becoming very familiar and proficient with using the device: if you are familiar

with one unit, you will be familiar with all units.

The VIP4G features:

 Standard Connectors for:

 1 WAN Ethernet Ports (RJ45)

 3 LAN Ethernet Ports (RJ45)

 Data Port (RS232/DB9)

 4-Pin: MATE-N-LOK Type Connector for Power

 6-Pin: MATE-N-LOK Type Connector for RS485 Data

 10-Pin: MATE-N-LOK Type Connector for Digital I/O

 Cellular Antenna (SMA Female Antenna Connection x2)

 WiFi Antenna (SMA Female Antenna Connection x2)

 Built in GPS (SMA Female Antenna Connection)

 Status/Diagnostic LED’s for CPU, POWER, RSSI, RF_ACT, GPS, CELL_ACT

 CFG Button for firmware recovery operations

 Mounting Holes

Image 3-1: Front View of VIP4G

Image 3-2: Rear View of VIP4G