User's Manual

iii
nMIMO2458 Regulatory Requirements
WARNING:
To satisfy FCC RF exposure requirements for mobile transmitting devices, a separation distance of 23 cm (33cm IC) or more should be
maintained between the antenna of this device and persons during device operation. To ensure compliance, operations at closer than this distance
is not recommended. The antenna used for this transmitter must not be co-located in conjunction with any other antenna or transmitter.
WARNING:
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received including interference that may cause undesired operation.
WARNING:
Changes or modifications not expressly approved by Microhard Systems Inc. could void the user’s authority to operate the equi pment. This device
has been tested with UFL to Reverse Polarity SMA connectors with the antennas listed in Appendix A When integrated in OEM products, fixed
antennas require installation preventing end-users from replacing them with non-approved antennas. Antennas not listed in the tables must be
tested to comply with FCC Section 15.203 (unique antenna connectors) and Section 15.247 (emissions).
WARNING:
MAXIMUM EIRP: Cannot exceed 31.51 dBm EIRP in 2.4 GHz band. Therefore, the sum of the transmitted power (in dBm), the cabling loss
and the antenna gain cannot exceed 31.51 dBm.
WARNING:
MAXIMUM EIRP: For devices with detachable antenna(s), the maximum antenna gain permitted for devices in the band 5725-5850 MHz
shall be such that the equipment still complies with the e.i.r.p. limits specified for point-to-point and non-point-to-point operation.
WARNING:
Be advised that high-power radars are allocated as primary users (i.e.prioirty users) of the bands 5250-535 0 MHz and 5650-5850 MHz and
that these radars could cause interference and/or damage to LE-LAN devices.
WARNING:
EQUIPMENT LABELING: The FCC and IC numbers depend on the model of the radio module. Do NOT use the Marketing Name of the
product but the Model to distinguish the Certifications Numbers. This device has been modularly approved. The manufacturer, product
name, and FCC and Industry Canada identifiers of this product must appear on the outside label of the end-user equipment.
WARNING:
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired
operation of the device.
WARNING:
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
SAMPLE LABEL REQUIREMENT for Model: nMIMO2458:
Contains:
FCC ID: NS915NM2458 IC : 3143A-15NM2458
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this
device must accept any interference received including
interference that may cause undesired operation.