User Guide

microHAM © 2004 All rights reserved
4. QUICK START
w Insert CR-ROM to the CD drive
w Run "urouter_release_xx_xx.exe" (xx_xx is version) from CD to start the installation and launch Router.
w Connect USB cable to the micro KEYER. Other cables left unconnected
w Plug second end of the USB cable to the computer USB port and install USB driver from location:
C:\Program Files\microHAM\driver\d2xx
w You should see tab with micro KEYER statement with yellow X mark
w Plug audio cables to the sound card and to the micro KEYER rear panel jacks. Computer Line Out to
micro KEYER Line Out, computer Line In to MK Line In and computer Mic In to MK Mic In.
w Turn OFF your radio
w Plug DB37 radio cable to the micro KEYER and other ends of the radio cable to the appropriate radio
jacks.
w Turn radio ON.
w Within three second you should see single flash of green FSK Led at the MK front panel and a few
seconds you should see Green OK mark at Router software next micro KEYER statement tab.
w Congratulation ! You can start playing with micro KEYER, but better read this manual now :-)
6