Setup guide
By Pete, N4ZR: I wanted to be able to use N1MMs FocusOther function to control where the entry
focus was when I was transmitting on one radio or the other. The greyed−out options for Computer
TX on R1 and R2 get in the way of that. If you uncheck Latch in the Headphone Switching area,
that disables those choices and lets N1MM be the boss.
Manual TX on R1/2: the ability to listen to sidetone when sending paddle CW = to hear sidetone in
both ears when sending manually.
Saving you work
Save settings to a preset by selecting menu Preset | Save as. Choose a position and name it:
N1MM−all modes.
Note: Each of the tabs is complex enough to warrant careful attention. Incidentally, it is always a good
idea to save your last working setup as a Preset, so that you can retrieve the situation if you mess up.
It also makes sense to save your experiments.
2.3 N1MM logger setup
Theres nothing magical about which ports are used for which purposes; you just have to be
consistent between N1MM Logger and the MicroHam Router.
Click Config| Configure Ports, Telnet Addresses, Other ...•
Hardware Tab•
PA1M Hardware Tab
3 = Winkey 4−6:No CW/Other 5−7: Digital + PTT + No CW! (CW = 3)
13−2−2009 2 PA1M − MK2R+ and N1MM logger setup 20