Setup guide

2.2 microHAM Router setup
Tab: Ports
Radio: Assign Radio 1 to COM4 and Radio 2 to COM5•
Click the Set button for each radio and select the radio on that port from the drop
down box.
♦
Uncheck?? the Disable router queries box.◊
Test: Check the radio by turning the VFO, frequency in uRouter should follow
frequency radio.
♦
FSK: Assign ports for FSK. DI−1 to COM6 and DI−2 to COM7 and uncheck the PTT box.•
NB. If you are not using N1MM Logger for RTTY contesting you can skip this step. ♦
If you are using the same port for PTT and FSK, uncheck the PTT box next to FSK. ♦
Further down set PTT to the same port as FSK and select RTS.♦
Test: Test buttons sends FSK (MK2R: PTT: green; CW/FSK blinks green)♦
2nd FSK: Not used•
CW: Not used•
PTT: Assign PTT Radio 1 to COM6 and PTT Radio 2 to COM7 and select RTS for both
ports.
•
2nd PTT: Not used•
Foot switch: Not used. Is output port to software, not supported by N1MM logger.•
Winkeyer 2: Assign COM3. Check Generate PTT1 on the CW/WinKey tab if you do not
intend to operate QSK.
•
Test: Test buttons sends test in CW on radio 1 (MK2R: PTT: green; CW/FSK red in
CW rhythm)
♦
Control: Assign COM 8•
13−2−2009 2 PA1M − MK2R+ and N1MM logger setup 12