Setup guide
Table Of Contents
- Table of Contents
- 1 General information (setting up microHAM and N1MM logger)
- 2 SO2R Setup at PA1M - microHAM MK2R+ and Station Masters and N1MM logger
- 2.1 Layout cabling
- 2.1.1 MK2R+ Station Master Connection diagram (by Joe, W4TV)
- 2.1.2 Shack PA1M
- 2.1.3 Stationmaster
- 2.1.4 Nr 6 - Port A - Antennaswitch (DB25F) microHAM DOUBLE TEN SWITCH
- 2.1.5 Nr 14 - Port B - bandpassfilter, sequencer (DB25F) ICE-419A BPF
- 2.1.6 Nr 5 - Port PA - Power Amplifier (DB15F)
- 2.1.7 Nr 13 - Port ROTOR - Antenna Rotator (DB15F)
- 2.1.8 StationMaster cabling
- 2.1.9 Setup Station Master
- 2.1.10 Setup uRouter
- 2.2 DOUBLE TEN Port lockout with Station Masters
- 2.3 Radio settings
- 2.4 microHAM Router setup
- 2.5 Station master setup
- 2.6 N1MM logger setup
- 2.7 MMTTY setup
- 2.8 PC setup
- 2.9 Errors and other problems
- 2.10 Detailed Cabling Diagrams
- 2.1 Layout cabling
- 3 N1MM - RTTY operation / settings
STORE the information to the Station Master. Otherwise NOTHING will change in the Station Master.
Tab: Rotator
...
Tab: Keyboard
Not in use yet
Tab: Display
For now the default settings are being used..
Tab: System Settings
Not in use as the function keys in N1MM logger control the Voice messages.
2.6 N1MM logger setup
Theres nothing magical about which ports are used for which purposes; you just have to be
consistent between N1MM Logger and the MicroHam Router.
Click Config| Configure Ports, Telnet Addresses, Other ...•
Hardware Tab•
PA1M Hardware Tab
Select: SO2R and Digital for Com6 and Com7
It is not necessary to check CW/Other on the "Digital" ports. PTT will function even if "Other" is not
checked.
COM3 to COM7 − set any unused handshake line (e.g., DTR) "Always Off" to prevent unwanted
transmission if something is not configured correctly.
13−2−20092 SO2R Setup at PA1M − microHAM MK2R+ and Station Masters and N1MM logger 35