Setup guide
Table Of Contents
- Table of Contents
- 1 General information (setting up microHAM and N1MM logger)
- 2 SO2R Setup at PA1M - microHAM MK2R+ and Station Masters and N1MM logger
- 2.1 Layout cabling
- 2.1.1 MK2R+ Station Master Connection diagram (by Joe, W4TV)
- 2.1.2 Shack PA1M
- 2.1.3 Stationmaster
- 2.1.4 Nr 6 - Port A - Antennaswitch (DB25F) microHAM DOUBLE TEN SWITCH
- 2.1.5 Nr 14 - Port B - bandpassfilter, sequencer (DB25F) ICE-419A BPF
- 2.1.6 Nr 5 - Port PA - Power Amplifier (DB15F)
- 2.1.7 Nr 13 - Port ROTOR - Antenna Rotator (DB15F)
- 2.1.8 StationMaster cabling
- 2.1.9 Setup Station Master
- 2.1.10 Setup uRouter
- 2.2 DOUBLE TEN Port lockout with Station Masters
- 2.3 Radio settings
- 2.4 microHAM Router setup
- 2.5 Station master setup
- 2.6 N1MM logger setup
- 2.7 MMTTY setup
- 2.8 PC setup
- 2.9 Errors and other problems
- 2.10 Detailed Cabling Diagrams
- 2.1 Layout cabling
- 3 N1MM - RTTY operation / settings
Enter antennas as connected to the TWO by TEN SWITCH.
A1 is port 1, A2 is port 2 etc.
RX only − this antenna is not for tranmitting
SteppIR − when it;s a SteppIR (not available here)
Rotator − if the rotator controller in the SM is turning this antenna
Offset − if the rotator has an offset
Tab: Antenna Switching & PTT Sequencer
Subtab: Virtual Rotators
Empty
Tab: Antenna Switching & PTT Sequencer
Subtab: Antenna Groups
Empty
Tab: Antenna Switching & PTT Sequencer
Subtab: PA & Sequencer
No settings yet
13−2−20092 SO2R Setup at PA1M − microHAM MK2R+ and Station Masters and N1MM logger 32