Setup guide
Table Of Contents
- Table of Contents
- 1 General information (setting up microHAM and N1MM logger)
- 2 SO2R Setup at PA1M - microHAM MK2R+ and Station Masters and N1MM logger
- 2.1 Layout cabling
- 2.1.1 MK2R+ Station Master Connection diagram (by Joe, W4TV)
- 2.1.2 Shack PA1M
- 2.1.3 Stationmaster
- 2.1.4 Nr 6 - Port A - Antennaswitch (DB25F) microHAM DOUBLE TEN SWITCH
- 2.1.5 Nr 14 - Port B - bandpassfilter, sequencer (DB25F) ICE-419A BPF
- 2.1.6 Nr 5 - Port PA - Power Amplifier (DB15F)
- 2.1.7 Nr 13 - Port ROTOR - Antenna Rotator (DB15F)
- 2.1.8 StationMaster cabling
- 2.1.9 Setup Station Master
- 2.1.10 Setup uRouter
- 2.2 DOUBLE TEN Port lockout with Station Masters
- 2.3 Radio settings
- 2.4 microHAM Router setup
- 2.5 Station master setup
- 2.6 N1MM logger setup
- 2.7 MMTTY setup
- 2.8 PC setup
- 2.9 Errors and other problems
- 2.10 Detailed Cabling Diagrams
- 2.1 Layout cabling
- 3 N1MM - RTTY operation / settings
Select Controlled by microHAM control protocol in the two drop−down boxes. Pins 6−9 and
10−13 are connected to two banddecoders which drive the microHAM 2by10 SO2R switch. Note that
these precisely pass through the antenna selections from the N1MM Logger Antenna tab − so you
can have multiple antennas on a given band, selectable from the keyboard.
Tab: Functions
13−2−20092 SO2R Setup at PA1M − microHAM MK2R+ and Station Masters and N1MM logger 27