Setup guide
Table Of Contents
- Table of Contents
- 1 General information (setting up microHAM and N1MM logger)
- 2 SO2R Setup at PA1M - microHAM MK2R+ and Station Masters and N1MM logger
- 2.1 Layout cabling
- 2.1.1 MK2R+ Station Master Connection diagram (by Joe, W4TV)
- 2.1.2 Shack PA1M
- 2.1.3 Stationmaster
- 2.1.4 Nr 6 - Port A - Antennaswitch (DB25F) microHAM DOUBLE TEN SWITCH
- 2.1.5 Nr 14 - Port B - bandpassfilter, sequencer (DB25F) ICE-419A BPF
- 2.1.6 Nr 5 - Port PA - Power Amplifier (DB15F)
- 2.1.7 Nr 13 - Port ROTOR - Antenna Rotator (DB15F)
- 2.1.8 StationMaster cabling
- 2.1.9 Setup Station Master
- 2.1.10 Setup uRouter
- 2.2 DOUBLE TEN Port lockout with Station Masters
- 2.3 Radio settings
- 2.4 microHAM Router setup
- 2.5 Station master setup
- 2.6 N1MM logger setup
- 2.7 MMTTY setup
- 2.8 PC setup
- 2.9 Errors and other problems
- 2.10 Detailed Cabling Diagrams
- 2.1 Layout cabling
- 3 N1MM - RTTY operation / settings
Tab: PTT
Radio 1 Radio 2
CW: PTT1 (microphone jack)
VOICE: PTT1 (microphone jack)
FSK/DIGITAL: PTT2 (rear panel jack)
PA PTT: Select
LNA PTT: unselect
CW in VOICE: ???
CW: PTT1 (microphone jack)
VOICE: PTT1 (microphone jack)
FSK/DIGITAL: PTT2 (rear panel jack)
PA PTT: Select
LNA PTT: unselect
CW in VOICE: ???
For CW/VOICE select PTT1 (microphone jack) and for FSK/DIGITAL PTT2 (rear panel jack).
If you are using QSK in CW select QSK for CW.
PTT Lead is the amount the transceiver PTT is delayed with respect to the PA PTT and should be
about the same as the INH time in Station Master.
PTT Tail applies only to WinKey (it is the "hold" time between elements).
NB The K3 has only one PTT (Mic, rear panel and ACC are all the same line) so PTT1 (mic cable)
and PTT2 (ACC plug) are the same to the K3.
13−2−20092 SO2R Setup at PA1M − microHAM MK2R+ and Station Masters and N1MM logger 22