Setup guide
Table Of Contents
- Table of Contents
- 1 General information (setting up microHAM and N1MM logger)
- 2 SO2R Setup at PA1M - microHAM MK2R+ and Station Masters and N1MM logger
- 2.1 Layout cabling
- 2.1.1 MK2R+ Station Master Connection diagram (by Joe, W4TV)
- 2.1.2 Shack PA1M
- 2.1.3 Stationmaster
- 2.1.4 Nr 6 - Port A - Antennaswitch (DB25F) microHAM DOUBLE TEN SWITCH
- 2.1.5 Nr 14 - Port B - bandpassfilter, sequencer (DB25F) ICE-419A BPF
- 2.1.6 Nr 5 - Port PA - Power Amplifier (DB15F)
- 2.1.7 Nr 13 - Port ROTOR - Antenna Rotator (DB15F)
- 2.1.8 StationMaster cabling
- 2.1.9 Setup Station Master
- 2.1.10 Setup uRouter
- 2.2 DOUBLE TEN Port lockout with Station Masters
- 2.3 Radio settings
- 2.4 microHAM Router setup
- 2.5 Station master setup
- 2.6 N1MM logger setup
- 2.7 MMTTY setup
- 2.8 PC setup
- 2.9 Errors and other problems
- 2.10 Detailed Cabling Diagrams
- 2.1 Layout cabling
- 3 N1MM - RTTY operation / settings
Tab: Audio Switching
Radio 1 − K3 Radio 2 − TS−2000
CW: AAA (always)
VOICE: CmCmCm (mic in
MK2R+)
CmCmA (mic in
soundcard)
FSK/DIGITAL: ?????
VOICE/DIGITAL: Select by
frequency
Use line out channel: Left
CW: AAA (always)
VOICE: CmCmCm (mic in
MK2R+)
CmCmA (mic in
soundcard)
FSK/DIGITAL: BBB
Use line out channel: Right
If you do not intend to use N1MM DVK, use ACmA. Radio 1:
Voice/Digital for the K3 should be "Use VOICE settings" since the K3 has a separate digital mode that
supports AFSK (AFSK A or DATA A).
Use line out channel: Left
Radio 2:
13−2−20092 SO2R Setup at PA1M − microHAM MK2R+ and Station Masters and N1MM logger 20