Setup guide

not allow data to flow properly from the logger to the radio.
PA1T: Check the "Forward autoinformation to CAT port" boxes with an Icom
radio.
◊
Test: Check the radio by turning the VFO, frequency in uRouter should follow
frequency radio.
♦
Radio 1 − Elecraft K3
Radio 2 − Kenwood TS2000
FSK: Assign ports for FSK. DI−1 to COM6 and DI−2 to COM7 and uncheck the PTT box.•
NB. If you are not using N1MM Logger for RTTY contesting you can skip this step. ♦
If you are using the same port for PTT and FSK, uncheck the PTT box next to FSK. ♦
Further down set PTT to the same port as FSK and select RTS.♦
Test: Test buttons sends FSK (MK2R: PTT: green; CW/FSK blinks green)♦
NB Don;t forget to set up the radio for FSK (K3
Select long DATA MD for FSK D per Band!!
)♦
2nd FSK: Not used•
CW: Not used•
PTT: Assign PTT Radio 1 to COM6 and PTT Radio 2 to COM7 and select RTS for both
ports.
•
2nd PTT: Not used•
Foot switch: Not used. Is output port to software, not supported by N1MM logger.•
Winkeyer 2: Assign COM3. Check Generate PTT1 on the CW/WinKey tab if you do not
intend to operate QSK.
•
Test: Test buttons sends test in CW on radio 1 (MK2R: PTT: green; CW/FSK red in
CW rhythm)
♦
Control: Assign COM 8•
13−2−20092 SO2R Setup at PA1M − microHAM MK2R+ and Station Masters and N1MM logger 19