Setup guide
Table Of Contents
- Table of Contents
- 1 General information (setting up microHAM and N1MM logger)
- 2 SO2R Setup at PA1M - microHAM MK2R+ and Station Masters and N1MM logger
- 2.1 Layout cabling
- 2.1.1 MK2R+ Station Master Connection diagram (by Joe, W4TV)
- 2.1.2 Shack PA1M
- 2.1.3 Stationmaster
- 2.1.4 Nr 6 - Port A - Antennaswitch (DB25F) microHAM DOUBLE TEN SWITCH
- 2.1.5 Nr 14 - Port B - bandpassfilter, sequencer (DB25F) ICE-419A BPF
- 2.1.6 Nr 5 - Port PA - Power Amplifier (DB15F)
- 2.1.7 Nr 13 - Port ROTOR - Antenna Rotator (DB15F)
- 2.1.8 StationMaster cabling
- 2.1.9 Setup Station Master
- 2.1.10 Setup uRouter
- 2.2 DOUBLE TEN Port lockout with Station Masters
- 2.3 Radio settings
- 2.4 microHAM Router setup
- 2.5 Station master setup
- 2.6 N1MM logger setup
- 2.7 MMTTY setup
- 2.8 PC setup
- 2.9 Errors and other problems
- 2.10 Detailed Cabling Diagrams
- 2.1 Layout cabling
- 3 N1MM - RTTY operation / settings
same band.
2.3 Radio settings
Proposed settings by microHAM:
Kenwood TS−2000 Elecraft K3
Menu nr.39 = INVERS•
Menu nr.50B = 5•
Menu nr.50C = 9•
Menu nr.50D = 9•
Turn OFF internal CW keyer in
the radio
•
LINE OUT − Nor 020•
PWR SET − PEr bAnd•
RS232 − 38400 b•
Select long DATA MD for FSK D per
Band!!
•
2.4 microHAM Router setup
Tab: Ports
Radio: Assign Radio 1 to COM4 and Radio 2 to COM5•
Click the Set button for each radio and select the radio on that port from the drop
down box
♦
Do not check the "Disable router queries" box (so empty them). With that
checked, Router no longer polls the radio and the internal flow control does
◊
13−2−20092 SO2R Setup at PA1M − microHAM MK2R+ and Station Masters and N1MM logger 18