User manual

23
9.5 Test sequences
This function allows you to run a special demo-test sequences without an external controller, which will show you
some possibilities of using CYCLOPS 150. Press [ ] or [ ] keys to select the "Mod1" or "Mod2"
sequences. The "Mod1" is suitable for projections on the wall, ceiling or ground without any head-movement, the
"Mod2" uses all CYCLOPS 150 functions and therefore is good for a complete introduction of the fixture.Select
"Mod1" or "Mod2" by [ ] or [ ] buttons and press [ ]-button to confirm the choice.If the test program is
running,messages "run/test" blink on the display.
If you want to pause the runnnig program in the required position, press the [ ]-button(messages"PAUS "/" test"
blink ).To continue the program running,press the [ ]-button again.
Personality Display Default values
(SHADED)
Pan reverse
Tilt reverse
Display intensity
Display- reverse
Displaypermanent
On
DMX
presetting
Blackout during
mov. correction
Pan/Tilt feedback
Microphone
sensitivity
Music trigger