Specifications

5
ENGLISH
Always disconnect the fixture from the power supply when it is not in use or
before cleaning it. Only handle the power cord by the plug; Never pull out the
plug by tugging on the power cord.
This device falls under protection Class I. Therefore it is essential to connect
the green conductor to earth, ensuring the the unit is properly grounded.
Only qualified technicians should perform electrical connections, repairs and
servicing of the fixture.
Do not connect this fixture to a dimmer pack.
Do not switch the fixture on and off in short intervals as this greatly reduces
the lamp’s life.
During the initial start-up some smoke or odour may arise. This is a normal
process and does not necessarily mean that the fixture is defective.
Do not touch the fixture’s housing barehanded during its operation
(housing becomes hot)!
When replacing use lamps and fuses use the same type and rating only.
CAUTION! BEWARE OF POTENTIAL EYE DAMAGE!
Avoid looking directly into the light source.
(Meant especially for epileptics)!
1.2 Operating the Fixture
This fixture is a moving head spot for creating lighting effects. This product has
been configured to operate with an alternating current of 120 V, 60 Hz and was
designed for indoor use only.
If the fixture has been exposed to drastic temperature fluctuation (e.g. after
transportation), do not switch it on immediately. The resulting condensation
might damage your fixture. Leave the fixture switched off until it has reached
room temperature.
Never operate the fixture without the lamp!
Avoid shaking the fixture or using brute force. Avoid brute force when installing
or operating the fixture.
Never lift the fixture by holding the projector head or arms, as this may damage
the pan & tilt motors. Always hold the fixture by the transport handles.