Specifications

8. Error and information messages

This message appears if you try to switch on the lamp within 5 minutes after

having switched it off (the lamp is too hot). The message will also appear on the

display if the lamp doesn't ignite within 28 seconds. The ARENA PROFILE

SPOT will store this information and automatically ignite the lamp when the 5

minutes period has expired.

The fixture attempted ignition of the lamp seven times unsuccessfully

(the HEAt message appeared six times before), and the display shows "LAEr",

meaning that the lamp could be damaged or even missing, the fixture is over-

heating (this can occur if the ambient temperature is 45° C or more) or there

could be a failure of the igniter or the ballast. Please install or replace the lamp,

check the ambient temperature or contact your dealer if the situation was not

caused by the lamp.

This message informs you that the main PCB does not communicate correctly

with the Control Panel.

(Color wheel error) This message will appear after the fixture resets if the mag-

netic indexing circuit malfunctions (sensor failed or magnet missing) or the step-

ping motor is defective (or its driver circuit on the main PCB). The colour wheel

is not located in the default position after reset.

(Rotating gobo wheel error) This message will appear after the fixture resets

if the magnetic indexing circuit malfunctions (sensor failed or magnet missing)

or the stepper motor is defective (or its driver circuit on the main PCB).

The rotating gobo wheel is not located in the default position after the reset.

(Rotating gobo indexing error) This message will appear after the fixture resets

and if the magnetic indexing circuit malfunctions (sensor failed or magnet miss-

ing) or the stepper motor is defective (or its driver circuit on the main PCB). The

rotating gobo is not located in the default position after the reset.