Specifications

29
ENGLISH
1. Calibration via the control panel
Press [Enter] and the [Up] and [Down] keys in order to display the following
messages: "Colo, EFEC, rGob, Grot" for very smooth function calibration.
Select one of them, press [Enter] and use the [Up] and [Down] keys in order to
adjust their right value from 0 to 255. Then press [Enter] to confirm or [Mode]
to cancel and return to the menu. This can be repeated for each calibration pa-
rameter if it is required. When the calibration is finished, it is necessary to use
the "ArES" function in order to write the calibration values to the memory
(EEPROM) and to reset the fixture in order to check the newly adjusted posi-
tions of the colour, gobo and effect wheels. When the reset of the fixture is fin-
ished, the display will show the "FCAL" message. Press [Enter] to repeat the
calibration or [Mode] to return to the "AdJ" menu.
2. Calibration via an external controller
Press [Enter] and the [Up] and [Down] keys in order to display the following
messages: "Colo, EFEC, rGob, Grot" - calibration parameters. Select one of
them and press [Enter]. Now you can calibrate the colour, gobo and effect
wheels by your controller. The DMX calibration protocol is described in the table
mentioned below.
DMX Calibration Protocol:
After having calibrated the desired functions press [Enter] to confirm (or [Mode]
to cancel and return to the menu without reset by the "ArES" function) and use
the "ArES" function in order to write the calibration values to the memory
(EEPROM) and to reset the fixture in order to check the new adjusted positions
of the colour, effect and rot. gobo wheels and gobo indexing.