Specifications

16
Configuration of the XLR connector:
Building a serial DMX chain:
Connect the DMX output of the first fixture in the DMX chain with the DMX input
of the next fixture. Always connect one output with the input of the next fixture
until all fixtures are connected.
Caution:
At the last fixture, the DMX cable has to be terminated with a DMX terminator.
Solder a 120 Ω resistor between Signal (–) and Signal (+) into a 3-pin XLR plug
and plug it in the DMX output of the last fixture.
3.7 DMX-512 connection between fixtures and controller
Individual bare DMX Control wires must not come into contact with
each other, otherwise the fixtures will not work properly or at all.
Only use a stereo shielded cable and 3-pin XLR plugs and connectors in order
to connect the controller with the fixture and one fixture with another.