Specifications

10
3. Installation
3.1 Fitting/Exchanging the lamp
DANGER!
Install the lamp with the fixture switched off.
Unplug from power supply before opening unit!
To insert the lamp, open the top cover of the head (see the drawings to identify
which cover is top) by loosening the 4 Phillips screws on the front and rear sides
of the top cover. Then open the small lamp cover by loosening the 3 thumb
screws (see the drawing). If changing the lamp,
remove the old lamp from the socket and insert
the new lamp. Do not install a lamp with a higher
wattage as it may generate temperatures the fix-
ture was not designed for. Damages caused by
non-observance are not covered by warranty.
Please follow the lamp manufacturer‘s notes! Do
not touch the glass-bulb barehanded during the
installation! Make sure that the lamp is installed
tightly into the lamp holder system. Adjust the opti-
mal distance 1-1.5 mm from the lens by turning
the screw "A" (see the drawings "Lamp adjust-
ment" next page). Then close the small lamp
cover by tightening the 3 thumb screws. Close the
top cover of the head and tighten the 4 Phillips
screws. Before striking the lamp, reset the "LAti"
counter in the main menu of the Control Board, by
pressing the "Up" and "Down" buttons in one
time and then confirming with the [Enter] button.