TABLE OF CONTENTS 1. INTRODUCTION AND UNPACKING 1 2. SAFTEY INSTRUCTIONS 1-2 3. OPERATION INSTRUCTIONS 2-3 4. MOUNTING AND INSTALLATION 4 5. DMX-512 CONTROL CONNECTIONS 5 6. PHOTOMETRIC DATA 6-7 7 DMX CHANNELS 8 8. KEY FEATURES 8 9. TECHNICAL SPECIFICATIONS 8 10. MAINTENANCE AND CLEANING 9 1. INTRODUCTION AND UNPACKING Thank you for purchasing the MICROH LED MAX ZOOM TRI wash fixture. For your own safety and knowledge, please read this manual before installing or operating the device.
This device falls under protection-class I, therefore it is essential that the device be grounded. The electrical connection must be carried out by a qualified technician. The device should only be used with rate voltage and frequency. Make sure that the available voltage is not higher than 120V as stated at the end of this manual. Make sure the power cord is never crimped or damaged in any way, as this could cause shock and damage.
- This unit has a total of 7 operating modes: Master/Slave, Auto, DMX, Sound Active, Colour Fade, Colour Chase and Static Colour. MASTER/SLAVE MODE - By connecting the 3 pin DMX, you can daisy chain up to 30 units on master/ slave mode. Daisy chain the fixtures together by plugging from the DMX output of the first fixture into the DMX input of the second fixture, and so on… - On your Master fixture set the unit to STATIC MODE, AUTO RUN, SOUND, COLOUR FADE or COLOUR CHANGE.
4. MOUNTING AND INSTALLATION Caution: For added protection, mount the fixtures in areas outside walking paths, seating areas, or in areas were the fixture might be reached by unauthorized personnel. Before mounting the fixture to any surface, make sure that the installation area can hold a minimum point load of 10 times the device’s weight. Fixture installation must always be secured with a secondary safety attachment, such as an appropriate safety cable.
Regardless of the rigging option you choose for your MICROH LED MAX ZOOM TRI wash fixture, always be sure to secure your fixture with a safety cable. The fixture provides a built-in rigging point for a safety cable on the hanging bracket as illustrated above. Be sure to only use the designated rigging point for the safety cable and never secure a safety cable to a carrying handle. 5.
6.
7
7. DMX CHANNELS CHANNEL DMX VALUE FUNCTION 000-189 DIMMER 190-250 FLASH (slow → quick) 251-255 NO FUNCTION CH2 000-255 RED CH3 000-255 GREEN CH4 000-255 BLUE CH5 000-255 Electric machine adjustment CH1 0=start 255=terminal 8.
. MAINTENANCE AND CLEANING The following points have to be considered during the inspection: 1) All screws for installing the device or parts of the device must be tightly connected, and must not be corroded. 2) There must not be any deformations on the housing, colour lenses, fixations or installation spots (ceiling, suspension, trussing). 3) Mechanically moved parts must not show any traces of wearing and must not rotate with unbalances.
