User Manual

A8 Configuration Manual - fm_1.2.6.3_v4.1.FCC.doc ASTRI Confidential & Restricted Access
Page 7 of 36

3.3 U SER L OGIN
After connecting to the A8, the user needs to enter a user name and password to login. Please
contact astri for the details if required.
You could change the login name and password in web-admin, as shown in Section 5.1.
The login name and password could be reset to the default settings in CLI (in Section 3.9) or in
BootRom (in Section 9.1).
3.4 B ASIC C ONFIGURATION
The channel frequency, TX power, ACL can be configured through command line interface
(CLI).
There are two basic commands:
1. GET : This command is used to retrieve the settings or parameters in A8.
Example : get channel
The above command is to retrieve the current channel configured in A8.
2. SET : This command is used to configure the A8.
Example : set channel 1
The above command is to configure the A8 to operate at Channel 1.
An example is shown in Figure 3.
Figure 3. An example in CLI