User Manual

A8 Configuration Manual - fm_1.2.6.3_v4.1.FCC.doc ASTRI Confidential & Restricted Access
Page 14 of 36

Repeat the setting in A8_BTS_2. You may need to reboot the BTS to make the setting effective.
Note: Since the 802.11b/g and 802.11a radios are sharing the same IP address, no additional IP
address is required. Please note that 802.11a turbo A mode is not supported by the hardware at
this moment.
3.9 R ESTORE C ONFIGURATOIN TO D EFAULT S ETTING
Command line syntax of restoring A8 to its default setting:
set factory
reboot
After the A8 rebooted, all parameters will be restored to its default values, except IPAddr,
IPMask and Gateway.
Note: You must “reboot” to restore the default settings. Don’t make any parameter changes
after typing the command “set factory” in CLI before allowing the unit to reboot.