User Manual

19
Getting Started
5 Setup Windows.
Follow the on-screen instructions.
l
The computer restarts several times. Do not touch the screen or
tablet buttons, and wait until the drive indicator has turned off.
l
After the computer is turned on, the screen remains black or
unchanged for a while, but this is not a malfunction. Wait for a
moment until the Windows setup screen appears.
l
Setup of Windows will take approximately
5 minutes / 20 minutes.
Go to the next step, conrming each message on the display.
l
Follow the steps below.
A
When “Enable sensors” is displayed, touch [Enable this sensor].
B
When the [User Account Control] screen is displayed, touch [Yes].
C
At the [Display Rotation Tool] conrmation screen, touch [Yes].

The computer restarts automatically, and the setting is enabled.
l
You can set the Wireless Network after the setup of Windows is
complete.

If “Get online” is displayed, select “Skip this step”.

“Join a wireless network” screen may not appear.
CAUTION
l
You can change the user name, password, image and security
setting after setup of Windows.
l
Remember your password. If you forget the password, you can-
not use Windows. Creating a password reset disk beforehand is
recommended.
l
Do not use the following words for user name: CON, PRN,
AUX, CLOCK$, NUL, COM1 to COM9, LPT1 to LPT9, @, &,
space. In particular, if you create a user name (account name)
that includes the “@” mark, a password will be requested at the
log-on screen, even if no password has been set. If you try to
log on without entering a password, “The user name or pass-
word is incorrect.” may be displayed and you will not be able to
sign in / log on to Windows
(
è
OPERATING INSTRUCTIONS - Basic Guide).
6 Update the on-screen manual
A
Connect to the internet. Log on to Windows as an administrator.
For further information, refer to
Connect to a network.
B
Update the on-screen manual.
On the Start screen, click the [Manual Selector] tile.
Double-click [Manual Selector] on the desktop.
Follow the on-screen instructions.
7 Create a recovery disc.
A recovery disc allows you to install OS and restore its factory de-
fault condition, in case, the recovery partition of the ash memory
is damaged. We recommend creating a recovery disc before you
begin using the computer.
Refer to
è
Reference Manual
“Recovery Disc Creation Utility”
about creating the disc.