User Manual

ManualsBrandsMicroelectronics Technology ManualsElectronicsRFID Mini PCI-E Card Module

Read Me First

This equipment may not be co-located or

operated with any other antenna or trans-

mitter.

This device meets the government’s re-

quirements for exposure to radio waves.

This device is designed and manufactured

not to exceed the emission limits for expo-

sure to radio frequency (RF) energy set by

the Federal Communications Commission

of the U.S. Government.

The exposure standard for wireless device

employs a unit of measurement known as

the Specic Absorption Rate, or SAR. The

SAR limit set by the FCC is

1.6 W/kg.



* Tests for SAR are conducted using stan-

dard operating positions accepted by the

FCC with the device transmitting at its

highest certied power level in all tested

frequency bands.

Although the SAR is determined at the

highest certied power level, the actual

SAR level of the device while operating

can be well below the maximum value.

This is because the device is designed

to operate at multiple power levels so as

to use only the poser required to reach

the network. In general, the closer you

are to a wireless base station antenna,

the lower the power output.

This product is restricted to indoor use due

to its operation in the 5.15 to 5.25

GHz

fre-

quency range. FCC requires this product to

be used indoors for the frequency range 5.15

to 5.25

GHz

to reduce the potential for harm-

ful interference to co-channel Mobile Satellite

systems. High power radars are allocated

as primary users of the 5.25 to 5.35

GHz

and 5.65 to 5.85

GHz

bands. These radar

stations can cause interference with and/or

damage this product.

25-M-W-1

This device complies with Part 15 of the FCC

Rules. Operation is subject to the following

two conditions:

(1) This device may not cause harmful inter-

ference, and

(2) This device must accept any interference

received, including interference that may

cause undesired operation.

Responsible Party:

Panasonic Corporation of North America

Two Riverfront Plaza

Newark, NJ 07102

Support Contact:

http://www.panasonic.com/contactinfo

6-M-1

FCC RF Exposure Warning:

This equipment is provided with external

antenna connector(s) for connection to

optional Car Mounter or Port Replicator

for mobile external mounted antenna(s).

External antenna(s) must be professionally

installed and cannot exceed recommended

maximum antenna gain as described in

individual provided supplement instructions

for wireless transmitters. The Car Mounter

is provided with Radiall/Larsen WLAN whip

antenna, type NMO5E2400BKTNC with

5dBi antenna gain. The maximum allow-

able antenna gain for the external WWAN

base whip antenna for the cellular band

is 4 dBi, PCS band is 3 dBi, LTE Band 4

is 3 dBi, LTE Band 17 is 9 dBi and 10 dBi

for LTE Band 13. Also, user must maintain

minimum 20 cm spacing between external

antenna(s) and all person’s body (excluding

extremities of hands, wrist and feet) during

wireless modes of operation.

32-M-1

USA Only: Disposal may be regulated in your

community due to environmental consider-

ations. For disposal or recycling information,

please visit Panasonic website:

http://www.panasonic.com/environmental

or call 1-888-769-0149

65-M-2

This product contains a CR Coin Cell Lithium

Battery which contains Perchlorate Material -

special handling may apply.

See www.dtsc.ca.gov/hazardouswaste/per-

chlorate/

38-M-1

A lithium ion battery that is

recyclable powers the prod-

uct you have purchased.

Please call

1-800-8-BATTERY

for information on how to

recycle this battery.

L’appareil que vous vous

êtes procuré est alimen-

té par une batterie au

lithium-ion.

Pour des renseignements

sur le recyclage de la batte-

rie, veuillez composer le

1-800-8-BATTERY.

48-M-1