User Manual

MTI RFID Reader Operation Manual PAGE: 18
43-RFID0900-E1-MANUAL
DATE: 18-04-2006
台揚科技股份有限公司
MICROELECTRONICS TECHNOLOGY INC.
ISO 9001 Certified
4.3.3 Connect
Before read/write tag, you need to establish connection between PC and
reader. Use [Connect] button to connect to reader. If application does not
connect, verify the PC and reader’s Ethernet network setting. Please refer to
Chapter 3 for further information
network PC
IP address 192.168.1.39
Subnet mask 255.255.255.0
Reader
IP address 192.168.1.200
port 100
4.3.4 Read Tag Data
To display tag data as the data is received from the reader by clicking the RF
On button. When tags are read, they are displayed in the window and the
statistics are updated.
When reader accepted the RF On command from computer, the TX LED light
on the shell of reader will turn on. On the other hand, TX LED light will turn off
when RF OFF. As following figure.
RF ON RF OFF
Figure 11
MTI Group Proprietary Information
Any unauthorized use, duplication, reproduction, or disclosure of this document may be
considered as infringement of MTI Group’s intellectual property rights, the infringer may
be accused and liable applicable legal penalties.
台揚集團智慧財產
任何未經授權逕予複製、重製、公開或使用本文之行為，將被視為侵害
台揚集團之智慧財產權，將可因此負擔法律責任。