User Manual

MTI RFID Reader Operation Manual PAGE: 16
43-RFID0900-E1-MANUAL
DATE: 18-04-2006
台揚科技股份有限公司
MICROELECTRONICS TECHNOLOGY INC.
ISO 9001 Certified
4.2 Startup
MTI RFID Reader Application can communicate with all MTI readers through the
Ethernet (TCP/IP) port. Verify your reader is connected to the correct port and
power up.
After connect power cord, the PWR LED light on the shell of reader will turn on. As
figure 7.
Figure 7
To start up MTI RFID Reader Application, perform the following:
1. Execute RFID DEMO AP.exe
2. The application will attempt to connect to using the most recent configuration
settings.
Note:
 The destination port for this application is required to set as 100, please refer
to chapter 3 for Ethernet configuration setting.
4.2 Version Identification
To determine the current version of your MTI RFID Reader Application, refer to
the status bar below the application.
Figure 8 Current version of the application
MTI Group Proprietary Information
Any unauthorized use, duplication, reproduction, or disclosure of this document may be
considered as infringement of MTI Group’s intellectual property rights, the infringer may
be accused and liable applicable legal penalties.
台揚集團智慧財產
任何未經授權逕予複製、重製、公開或使用本文之行為，將被視為侵害
台揚集團之智慧財產權，將可因此負擔法律責任。